Quadwheel

The high-performance Quadwheel gives you a faster sweep speed, with 15" gap between tooth sets. Get maximum cutting power with only 4 Holders and 12 Teeth.

The key behind is the strategic placed gaps between the sets of teeth. With only one set of teeth engaged at a time, your motor has a chance to regain RPM before starting the next cut. Tooth holders are placed off-center, so the teeth nuts are on the center line of the wheel where they are best protected from wear.

The tooth holder also extends the teeth away from the face of the wheel, reducing wheel wear and freeing up horsepower to cut. This is one of the reasons the Quadwheel is able to use the 900 series on smaller horsepower machines, and deliver a smooth, consistent cut without climbing and jumping.

Every Quadwheel kit comes with everything you need to bolt to your existing shaft and hub, with installation instructions.

Order the Quadwheel for Your Stump Grinder

The Quadwheel is manufactured to fit a wide range of stump cutters. Inquire for the price and availability of a Quadwheel for your machine.

• by phone: 1 (800) 268-2141
• by email: weborders@wesspur.com

All Quadwheels have free shipping in the contiguous USA, right to your shop!

Each Quadwheel is sold with a full compliment of Greenteeth and bolts. The Quadwheel uses six of the 900 Series Wearsharp Greenteeth, and does not require spacers.

WARNING: This product can expose you to chemicals including Cobalt and Nickel, which are known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov. The following chemicals have been identified by the State of California to cause cancer. Cobalt CAS ID #: 7440-48-4, Nickel CAS ID #: 7440-02-0.