Wearsharp is the newest tooth technology from Greenteeth. As you cut through stumps and wear down the carbide it maintains a sharp cutting edge. This increases the lifespan of each tooth. Like all Greentooth, you can rotate the Wearsharp teeth to a fresh side before replacing. The Wearsharp teeth will work with the pockets of the corresponding series.
Wearsharp Greenteeth also fit the Greenwheel!
Wearsharp is the newest tooth technology from Greenteeth. As you cut through stumps and wear down the carbide it maintains a sharp cutting edge. This increases the lifespan of each tooth. Like all Greentooth, you can rotate the Wearsharp teeth to a fresh side before replacing. The Wearsharp teeth will work with the pockets of the corresponding series.
WARNING: This product can expose you to chemicals including Cobalt and Nickel, which are known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov. The following chemicals have been identified by the State of California to cause cancer. Cobalt CAS ID #: 7440-48-4, Nickel CAS ID #: 7440-02-0.
The Greenwheel and Quadwheel use a 2-sided, Wearsharp Greentooth. These sharp cutters wear to a fresh cutting surface instead of rounding over like other stump teeth. This provides a consistent cut for the life of the tooth, and you maintain a faster sweep speed.
WARNING: This product can expose you to chemicals including Cobalt and Nickel, which are known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov. The following chemicals have been identified by the State of California to cause cancer. Cobalt CAS ID #: 7440-48-4, Nickel CAS ID #: 7440-02-0.
500-series: for machines 16hp and smaller. Remember to order bolts below. Sold individually.
700-series: for machines with 18 to 35hp. Remember to order bolts below. Sold individually.
900-series: for machines with 35 to 65hp. Remember to order bolts below. Sold individually.
Bolts for use with LoPro pockets. Sold individually.
The 1100-series is the largest in the Greenteeth® family. The 1100 is best-suited for larger machines from 66 to 200hp. Remember to order bolts below. Sold individually.
The GreenBolt is built with external drive head for easier installation and removal vs. a standard Allen bolt.
The head on the GreenBolt is a 5/8” hex, and secures with a 3/4” nut. Sold individually.
This anti-seize compound also lubricates nuts and bolts to help prevent rust and corrosion and seizing up. We recommend using Green-Seize anti-seize when you install your Greenteeth® pockets. 8oz or 16 oz brush-top cans.
1/2" Allen wrench for Greenteeth® bolts.
Diamond grinding wheel measures 4” x 1/4” x 1”. For carbide tools.
Standard 6" & 8” green wheels for sharpening carbide tips on stump grinder teeth. Pearl brand bench grinding wheels are designed for use on work benches or floor standing machines. Wheels are not affected by water, oils or acids. Each wheel is balanced and ring tested. One size wheel can fit several different machines using the included bushing set. Use Green Silicon Carbide bench grinding wheels for fast burr free grinding of tungsten carbide tipped tools, ferrous and non-ferrous metals.
6” Wheel x 3/4” x 1” - C80 Grit - MAX RPM: 4,140
8” Wheel x 1” x 1” C120 Grit - MAX RPM: 3,600
Warning! Carbide dust is harmful if inhaled. A respirator must be worn while using the Green wheel.
